INSTALLATION OF CARD
1- At first, shut down the computer and open the case door.
2- Remove the on/off case key (power) from motherboard and instead connect to motherboard power SW.
3- Put the card in an empty PCIe port and close its screw.
4- Connect the power key that separated in second stage to the card in power SW.
5- Separate the LED wire of on/off mode and hard disk from motherboard and connect to the card in the specified areas as per following figure.
6- Separate the hard disk data cable from motherboard and connect to the card to SATA local.
7- Separate the data cable of CD drive from motherboard and connect to the card in SATA internet (optional).
8- Close the case door.
9- Connect the NIC network port by network cable available in the box to the computer’s network port.